Anionic Emulsions

There are three major classifications of emulsion grades: rapid-setting, medium-setting, and slow-setting. The terms “rapid,” “medium,” and “slow” relate to the amount of time it takes for the emulsion to cure and the amount of mixing that can be performed before the emulsion breaks. Emulsions that allow for the longest mixing times generally take the longest to cure, while emulsions that allow for very little mixing time are those that set and cure most rapidly.

Chemical surface-active agents, serving as emulsifiers, are classified by the electrochemical charge that is attained when they dissociate in a water solution. In the case of anionic emulsions, the chemical charge is negative. The chemical type and quantity of surface-active agents used in the manufacturing process governs the process in which the resulting asphalt emulsion can be used.

Safety Data Sheets

Description	Pdf File
SDS – Anionic Medium Setting Emulsion
SDS – Anionic Rapid Setting Emulsion
SDS – Anionic Slow Setting Emulsion
SDS – Enviro-Prem

Related Resources

Description	Pdf File
Research – Asphalt Surface Treatments and Seal Coats
Research – A General Method of Design for Seal Coats and Surface Treatments
Research – Introduction to Asphalt Emulsions
Research – Overview of the Design of Emulsion Based Seal Coat Systems in Canada and Abroad
Research – Bio-Solvents in the Production of Emulsified Prime Coat Systems
Research – 12-Year Performance Review of Bloomington Road (York Region Road 40) Rehabilitation using Cold In-Place Recycling and a 6.7 mm Fine Stone Mastic Asphalt
Research – New Brunswick Field Study on Optimization of Tack Coat Rate to Enhance Interface Bonding of Asphalt Layers
Specifications – McA Anionic Emulsions
Product Data Sheet – ACM-5
Product Data Sheet – Clean Bond Coat
Product Data Sheet – Enviro-Prem
Product Data Sheet – HF-150P
Product Data Sheet – HF-150S
Product Data Sheet – HP-200
Product Data Sheet – PAPvlw
Product Data Sheet – RS-1
Product Data Sheet – SS-1
Fact Sheet – Slurry Micro Systems
Fact Sheet – Cold Mixed Asphalts
Fact Sheet – Seal Coating
Fact Sheet – Recycling & Rehabilitation
Pavement Process Overview – Tack Coats
Pavement Process Overview – Chip Seals
Pavement Process Overview – Dense Graded Cold Mixes
Pavement Process Overview – Dense-Graded Seal Coats
Pavement Process Overview – Open Graded Cold Mixes
Pavement Process Overview – Rejuvenating Seals
Field Trial – Hot Mix Asphalt over Enviroprem Trial, Rte 8/Rte 107, Connector
Product Data Sheet – Colasphalt Prime
Product Data Sheet – CSPE
Product Data Sheet – HP-200P
Product Data Sheet – HF-250S
Product Data Sheet – HF-500M-HR
Product Data Sheet – HP-400